Zibo ShiNaite anti - corrosion Technology Co., Ltd
Contact: Wang Zhong
mobiles: 17663023308 15589303703
Address: Zibo City, Shandong Province Linzi District Qilu International Plastic City fine plasticized area 11-1
SNT-800 large particles wear-resistant protective agent is spherical large particles of ceramic and other filler-based wear-resistant composite ceramic materials. Two-component, black and gray clay, and metal substrate bonding strength, toughness, wear resistance, corrosion resistance, aging resistance, room temperature curing, heating curing can get better overall performance; Drip, available scraper smear into any shape, easy to use.
SNT-800 large particle wear-resistant protective agent for coarse particle impact conditions on the equipment to repair large area wear or pre-protective coating. Such as: cement, electricity, coal washing, mineral processing industry pipe, elbow, chute, cyclone, separator, slurry pump, screw conveyor and other wear and tear repair.
Operating time limit
SNT-800 large particles
Wear protection agent
1. Surface treatment: roughening the area to be treated, sandblasting and rusting; rinse the roughened surface; the treated surface should be roughened, fresh and fresh substrate surface, and should be free of oil, no dust.
2. Preparation: according to the provisions of the proportion of SNT-800 large particles wear-resistant protective agent A, B two components by 4: 1 mixed evenly, and run out in 30min. Usually the side of the construction side of the configuration, a configuration of the largest amount can not exceed 1.5 kg, too much solidification of solid too fast, not exhausted has been partially solidified and can not be used. Can be based on the actual temperature in winter may be appropriate with more appropriate summer with less If the temperature is too low, the A component can be properly heated to reduce the viscosity to facilitate the configuration.
3. Coating: SNT-800 large particles wear-resistant protective agent suitable coating thickness is 4-15mm, should be mixed with a good layer of material to be coated in the repair area, the first layer to be compact, so that with the base The material is fully submerged; the coating is applied to the surface after the coating to be flattened, the material can not be machined, should pay attention to control the coating thickness, so as to avoid interference in the assembly phenomenon.
4. Curing: 25 ℃ curing 24 hours can be put into use, if the temperature should be heated or prolonged curing time to promote curing; general winter construction can be used iodine tungsten from the coating 40cm distance irradiation heating.
Transport Storage: Cool and dry place sealed storage, shelf life of 1 year. Transport to avoid inversion, to avoid bumps, according to non-dangerous goods transport.